MK – Material testing with cooling capacity
The MK environmental simulation chamber is designed for cyclical temperature testing. It masters all heat and cold tests between -40 °C and +180 °C and is characterized by its accuracy and performance.
MKF – Material testing with cooling capacity and vapor pressure humidification
Apart from a temperature range of -40 °C to +180 °C, the MKF unit has an additional humidification system and automatic water management system. The drift-free capacitive humidity sensor is responsible for measuring the values and ensures accurate test results. The required temperatures and humidity values in the range of 10 – 98% RH are quickly achieved and accurately maintained to cover even the most demanding alternating climatic profiles. The MKF series meets the requirements of international standards such as EN, IEC or MIL.
MKT – Material testing with cooling capacity and extremely low temperatures
With its extremely low temperatures from -70 °C, the MKT takes off where MK and MKF units stop. Demonstrated by its rapid heating up and cooling down times, it meets the highest demands on extremely low temperature testing and complex test cycles.
MKFT – Material testing with cooling capacity, vapor pressure humidification and extremely low temperatures
The all-rounder among environmental simulation chambers has a temperature range of -70 °C to +180 °C and a humidification system with humidity values of 10 - 98% RH. The electronically controlled humidification and dehumidification system with capacitive humidity sensor and innovative vapor pressure humidification come into full use. The dynamic climate change and rapid heating up and cooling down times alone cover complex standardized climate testing, e.g. PPV 4017.
APT-COMTM DataControlSystem for accurate documentation
As with all BINDER units, value was placed on reliable documentation of test results in developing the MK, MKT, MKF and MKFT units. The system includes continuous monitoring of processes and documents compliant work from simple measurements to complex tasks. A network cable can be used to easily transfer the data to a PC where it can be read. For this reason, BINDER units have an Ethernet interface standard.
APT-lineTM creates homogeneous climate conditions
To achieve a representative result regardless of size and quantity, the environmental simulation chambers from BINDER use APT-lineTM Technologie that is specific to BINDER units. The hot air is directed horizontally from both sides throughout the inner chamber and there can circulate evenly throughout the space. This has the advantage that test conditions remain constant throughout the entire usable space and that reliable test results are achieved even under full load.